5.2 General
P
fig. 15
G
fig. 16
The mattress heating is adjusted with
the remote control (fig. 15). You can choose
between manual or automatic control of the
heating and drying functions. These functions
can be programmed and the procedure is
explained in this chapter.
You can set the temperature of the foot zone
(G) and the body zone (H) (fig. 16)
independently of each other.
The pilot lights on the remote control indicate
the set temperature level. It takes about two
hours to heat the mattress to the preset
temperature level.
Please keep this in mind and activate the
heating function in time before going to bed.
The maximum heating period is limited to 12
hours. After 12 hours the heating system will
be switched off automatically.
GB32
2232 BinnenW.pdf - pag.32
start
end
now
P
H
LET OP !!! Lage resolutie!
People lose about a quarter of a litre of
moisture at night while sleeping. The mattress
largely absorbs this moisture. Activate the
drying function after getting up in the morning
to keep the mattress in top condition.
5.2.1 Manual body zone heating control
A
P
start
P
H
Setting the heating level
Set the heating level with the – and + buttons
(A and B).
The pilot lights at the top indicate the set
heating level.
The maximum heating level for use during the
night while sleeping or lying down is level 5.
(Maximum of 5 indicator lights on the remote
control being lit up.)
B
end
now
fig. 17
fig. 18
August 11, 2006