Pre-Programmed Settings - Auping Ultimate Climate Gebrauchsanweisung

5.3.2 Pre-programmed settings

The Ultimate Climate Advanced is pre-
programmed on delivery. When you activate
the program, the mattress heats and dries
according to the settings in the table below.
Start heating
Body zone
Foot zone
Stop heating
Start drying
Current time
5.3.3 Setting/adjusting personal preferences
Although the Ultimate Climate Advanced is pre-
programmed on delivery (see Chapter 5.3.2:
Pre-programmed settings) you can always
adjust these settings to your personal
preferences, for example if you find that the
heating level of the body zone is too low.
In this chapter you can read which settings
you can program yourself.
Please note: If you do not operate any key for
more than ten seconds, the settings entered
up to that time will be saved automatically. The
pilot lights will go out. In that case press the
key to continue programming.
P
2232 BinnenW.pdf - pag.35
21.00
level 4
level 5
09.00
11.00
00.00
LET OP !!! Lage resolutie!
A. Before adjusting your preferences
Make sure that the program is activated (see
Chapter 5.3.1: Activating/deactivating the
program) before you start programming
(adjusting your preferences).
B. Adjust heating starting time
A
START HEATING
– 20:00
P start
P
C F
Press the button (F)
The pilot light below the symbol
illuminated.
The text START HEATING will appear in the
display with the time at which heating
commences.
Adjust the starting
– and + buttons (A, B, C or D).
Please note: Set the time to at least 2 hours
before you go to bed.
B
+
end now
fig. 26
D
.
P
will be
start
time with
GB35
August 11, 2006
the