Fancom AT-Serie Anleitung Seite 11

AT(M) 63-80
Do not touch any of the AT(M) moving parts.
Fancom advises to leave the AT(M) on for about 6 hours after installation, to let it run in.
The AT(M) requires no specific maintenance. Fancom recommends that your installation technician inspects the
complete climate installation, of which the AT(M) is a component, every half-year.
Inspect the AT(M) periodically for any damages. Notify your installation technician immediately of any
damages. A damaged AT(M) is unsafe!
Check the AT(M) for proper functioning regularly.
There must always be power to the AT(M). This prevents the formation of condensation in the AT(M).
The AT(M) may be cleaned wet, but consider the following:
Do not use a high pressure hose or aim at motor seals or openings at close range.
Do not use water or high pressure cleaners for lengthy periods. The AT(M) contains rotating parts, the
throttle vanes. This means the construction is not completely waterproof.
Do not turn the AT(M) during or after the cleaning process. Note that the air inlet side is always on the
bottom side.
Gndfir
g
8