Adjusting The Transverse And Longitudinal Inclination Of The Rotors; Spring Tines Arms - Work / Transport Setting - SIP STAR 850/26 T Betriebsanleitung

Instruction for work
8
A
9
–
Check if the distance between tines and even
ground (A) is about 25 mm.
–
Deviation can be annuled by turning the spindle (1)
on the rotor.
–
Clean swathing is achieved with proper
tines height adjustment.
3.1.3 Adjusting the transverse and longitudinal
inclination of the rotors
Rotors must stand flat also transversally and
longitudinally . The rotor has on the chassis on the
outer side and in front a pair of wheels, which are
height adjustable.
10
–
–
1
3.2 Spring tines arms – work / transport setting
Replace the spring tines arms only when the transport
position is lowered, only outer four arms of each rotor.
14
A
B
Check if the rotor is set flat in transverse and
longitudinal position, seen in driving direction.
Annul the deviation:
a) Pull out the safety device (1)
b) Replace the washers (2) properly above (A) or
under (B) the holder (3)
c) Secure with safety device (1)
–
Clean swathing is achieved if the rotor
stands flat in transverse and
longitudinal position.
–
Mounting the spring tines arms from
transport to work position or from work
to transport position pay attention not
to stretch unintentionally the spring
safety pins. Risk of accident!
–
Mount the spring tines arms with the
switched off engine only! Remove the
ignition key.
–
Always mount the pins against the
rotor's rotation direction.
1
2
3