Storage; Restart For A New Season - SIP STAR 850/26 T Betriebsanleitung

Instruction for work
–
Use the grease on vegetable basis.

6. Storage

1. Place the machine in a dry place. Not near the
mineral manure storehouse.
2. Clean the machine inside and outside thoroughly.
Dirt holds moisture and causes rust. Cleaning with
high pressure cleaner is not recommanded.
3. Check flexible parts such as stay wires, joints and
other, demount and clean them, check the wear
out. Replace with spare parts if needed.
4. Lubricate all the parts of P.T.O. shaft connections.
5. After cleaning grease the machine thoroughly.
6. Grease the bearing of P.T.O. shaft protection to
reduce agglutination.
7. Repair the paint damage, protect the bright
surfaces with a remedy for rust.
8. Grease the contact area on the spring tines arm
and rotor plug.
9. Reduce the tyre pressure to discharge it and
protect tyres from sun, grease and oil.
10. Make a list of necessary spare parts and order
them in time. It easier for SIP-sellers to order and
deliver them out of season. Beside that the
machine is fully prepared and ready for work in the
new season.

7. Restart for a new season

1. Wipe the oil and grease used for the conservation
of the machine.
2. Lubricate the machine thoroughly to eliminate the
possible condensation moisture from bearings.
3. Check the tyre preassure.
4. Check the level of lubricant in the gearings, refill it
if needed.
5. Check and tighten all nuts and screws.
6. Check all the settings on the machine and re-set
them if needed.
7. Check the overload safety clutch of the P.T.O.
shaft, if the metal parts of slide lining become
loose (look inside).
8. Read carefully the work and safety instructions
again.
26