Initial Operation; Recharging The Battery; Practical Tips; Operation - Parkside PKGA 20-Li B1 Originalbetriebsanleitung

Initial Operation

Recharging the battery

Ensure that the ambient tem-
perature does not exceed
50 °C or fall below 0 °C dur-
ing the charging process.
Do not subject the battery to strong
sunlight over long periods and
do not leave it on a heater (max.
50 °C).
Allow a hot battery to cool before
charging.
The charging time is approx. 1 hour
(PAP 20 A1) or approx. 2 hours
(PAP 20 A3).
1. Remove the battery (9) from the appli-
ance if necessary.
2. Insert the battery (9) in the charging
compartment of the battery charger
(14).
3. Plug the battery charger (14) into a
mains outlet.
4. When the battery is fully recharged
unplug the battery charger (3) from the
mains.
5. Pull the battery (9) out of the battery
charger (14).

Practical tips

When working with the ap-
pliance, always wear suita-
ble clothing and appropriate
protective equipment.
Prior to each use it must be
ensured that the appliance is
working correctly.
Personal protective equip-
ment and a fully functional
appliance reduce the risk of
injuries and accidents.
Ensure that the ambient tem-
perature does not exceed
45 °C or fall below -20 °C
during work.
Wear ear protection.

Operation

Replacing the appliance at-
tachment
Secure the appliance against
switching on (see "Switch-
ing on/off") or remove the
rechargeable battery from
the appliance. There is an
injury hazard if the device is
switched on accidentally.
Wear safety gloves. The appliance
attachment might have heated up
after use.
Removing appliance attachment
1. Push the unlocking lever (5) into posi-
tion as far as the stop and then
hold it in this position.
2. Pull the unlocked appliance attachment
off (4/16/22/26).
Fitting appliance attachment
4. Push the appliance attachment
(4/16/22/26) along the guide rail
into the motor unit (6). It locks into
place audibly.
5. Allow the unlocking lever (5) to slide
back into position
IE NI CY
.
15