Changing tools
♦
Turn the quick-release chuck
RELEASE
to open it.
♦
Insert the desired tool into the quick-release
chuck
.
♦
Turn the quick-release chuck
GRIP
to tighten the tool.
Operation
Select operating mode
Function selector switch
♦
Push the function selector switch
engages at the required symbol:
Function
Drilling
Impact drilling
Select direction of rotation
WARNING!
►
The rotation direction switch
be used/adjusted if the appliance is at a
standstill.
♦
Select the direction of rotation by pressing the
rotation direction switch
right.
Preselecting the rotation speed
You can use the rotational speed preselector
adjusting wheel
speed. The speed you select depends on the
material to be processed. Work out the right
setting by carrying out a practice test.:
NOTE
►
The appliance only reaches the set rotational
speed during continuous operation.
PSBM 750 B3
towards
towards
so that it
Symbol
may only
towards the left or
to preselect the rotational
Switching on and off
Switching the appliance on
♦
Press the ON/OFF switch
Switching the appliance off
♦
Release the ON/OFF switch
Switching to continuous operation
♦
Press the ON/OFF switch
pressed position with the ON/OFF switch lock
button
.
Switching off continuous operation
♦
Press the ON/OFF switch
again.
Maintenance and cleaning
WARNING! RISK OF INJURY! Switch
the appliance off and remove the
power plug before starting any work
on the appliance.
■
Never permit liquids to penetrate inside the
appliance.
■
Use a soft, dry cloth to clean the housing.
Never use petrol, solvents or cleansers which
can damage plastic.
■
Always clean the appliance after completion of
work.
■
Store the appliance in a dry place.
WARNING!
►
If the connecting cable needs to be replaced,
order the replacement from the manufacturer
or an authorised representative in order to
avoid safety hazards.
NOTE
►
Replacement parts not listed (such as carbon
brushes, switches) can be ordered via our
service hotline.
.
.
. Lock it in the
and release it
GB │ IE │ NI │ CY
│
7
■