Motor Unit With Multisander Attachment Pkga2; Attaching/Removing Sanding Sheet; Selection Of Sanding Sheet - Parkside PKGA 20-Li B1 Originalbetriebsanleitung

3. Start with a lower torque step and in-
crease as required.
The direction change may only be
actuated when the appliance is at a
standstill!
The necessary torque is dependent
on:
- the type and hardness of the ma-
terial to be treated;
- the type and length of the screws
used.
Motor unit with
multisander attachment
PKGA2
Secure the appliance against
switching on (see "Switch-
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
Wear a protective mask during
grinding work.
Attaching/removing sanding
sheet
The sanding plate (
Velcro for rapid attachment of the sanding
sheet.
Attaching sanding sheet
1. Press the sanding sheet (23) evenly
onto the sanding plate (21). Ensure
that the holes in the sanding sheet
are placed above the openings in the
sanding plate.
Removing sanding sheet
2. Simply pull the sanding sheet (23) off
the sanding plate (21).
21) is fitted with
Connecting dust extraction
You can reduce dust production during
sanding by attaching a dust extraction
system.
1. Push the adaptor (24) into the opening
on the multi-sander attachment (22) as
far as the stop.
2. Connect a dust extractor suction hose
to the adaptor (24).
If necessary, you can connect the
suction hose of a vacuum cleaner
without reducer (25) to the adapter
(24).
Sanding
• Use a dust extraction system when
sanding with the multi-sander attach-
ment.
• Move the appliance against the work-
piece once it is switched on.
• Clean the sanding plate before you at-
tach a sanding sheet.
• Only work with sanding sheets in per-
fect condition to achieve good sanding
results.
• Work using low and even pressure.
This protects the appliance and the
sanding sheet.
• Do not use the same sanding sheet to
sand different materials (e.g. metal
and then wood).

Selection of sanding sheet

Grain size P Application
for pre-sanding rough wood
P 60
surfaces
P 80 / 120 for plain sanding
IE NI CY
17