Parkside PKGA 20-Li B1 Originalbetriebsanleitung Seite 13

reach underneath the
workpiece. Always stand
to the side of the saw
when working. Upon con-
tact with the blade there is a
risk of injury.
• Only when the electric
tool is turned on should
the sawing blade be
moved against the work-
piece. There is a risk of kick-
back if the tool insert jams in
the workpiece.
• Make sure that the foot-
plate is securely placed
against the workpiece
during sawing. The saw-
blade can tilt and lead to loss
of control over the power tool.
• After you have finished
work, turn the power
tool off and do not pull
the sawblade out of the
cut until it has come to a
standstill. In this way you will
avoid any kickback and can
safely put down the power tool.
• Use only undamaged
sawblades in perfect con-
dition. Bent or blunt blades
can break, adversely affect the
cut or cause kickback.
• Do not brake the saw-
blade after switching the
appliance off by applying
side pressure. The sawblade
may be damaged, break or
cause a kickback.
• Tighten the material
firmly. Do not support the
workpiece by hand or
foot. Do not touch any objects
or the ground with the saw
running. There is a risk of kick-
back.
• Hold the power tool tight-
ly with both hands while
working and ensure a se-
cure footing. The power tool
is guided more securely with
both hands.
• Wait until the power tool
has stopped before plac-
ing it down. The tool insert
can tilt and lead to loss of con-
trol over the power tool.
• Switch the appliance off
immediately if the sawing
blade jams. Spread the saw
cut out and pull the blade out
carefully. This can lead to loss
of control over the power tool.
3) SPECIAL SAFETY
INFORMATION DURING
SANDING AND SCRAPING
• Only use the power tool
for dry sanding. Do not
scrape moist materials.
Penetration of water into the
power tool increases the risk of
electric shock.
IE NI CY
13