Hazards Caused By Entanglement; Hazards During Operation - Parkside IAN 339157_1910 Originalbetriebsanleitung

Hazards caused by entanglement

■ Hazards caused by entanglement can result
in suffocation, scalping and/or cut wounds if
loose clothing, personal jewellery, necklaces,
hair or gloves are not kept away from the
machine and its accessories .
■ Gloves can get caught in the rotating drive,
which can lead to injuries or fractures of the
fingers .
■ Rubber or metal-reinforced gloves can become
entangled easily in rotating drive fittings and
extensions .
■ Never wear loose-fitting gloves or gloves with
cut-off or worn-out glove fingers .
■ Never hold onto the drive, the fitting or the drive
extension .
■ Keep your hands away from the rotating drive .
■ Dress properly . Do not wear loose clothing
or jewellery . Keep hair, clothing and gloves
away from the compressed-air tool and moving
parts . Loose clothes, jewellery or long hair can
be caught in moving parts . There is a risk of
personal injury .
■ Always wear impact-resistant safety goggles
during operation, repair or maintenance work
and when replacing accessory parts on the
drill or thread cutter . The level of the required
protection must be evaluated separately for
each individual task .
PDBS 1800 A1

Hazards during operation

■ When using the machine, the operator's hands
may be exposed to risks such as crushing, strik-
ing, cutting, abrasion and heat . Wear suitable
gloves to protect your hands .
■ Avoid contact with the rotating shaft and the
accessory tool to prevent cuts on your hands
and other body parts .
■ The operator and maintenance personnel must
be physically capable of handling the size,
weight and power of the machine .
■ Hold the machine correctly: be ready to coun-
teract any normal or sudden movements – keep
both hands ready .
■ Ensure that your body is balanced and that you
have stable footing .
■ Keep proper footing and balance at all times .
■ High reaction torques can occur in the event
of a jam/blockage, which can be caused by
excessive loads working on the drill, jamming of
the drill in the work material being processed or
by the drill cutting through the material .
■ Prevent unintentional starting . If the air supply is
interrupted, switch off the compressed-air tool
using the On/Off switch .
■ When aids are needed to absorb the reaction
torque, we recommend using a suspension unit
wherever possible . If this is not possible, side
handles for machines with a straight grip and
machines with pistol grip are recommended .
We recommend always using aids to absorb
the torque if it is higher than 4 Nm on machines
with straight grips, and higher than 10 Nm on
machines with a pistol grip, and higher than
60 Nm on offset screwdrivers .
■ Release the start/stop control in case of a
disruption to the electricity supply .
■ Use only the lubricants recommended by the
manufacturer .
GB │ MT │ 39 ■