Herunterladen Inhalt Inhalt Diese Seite drucken

Charging Process - Parkside PKGA 20-Li B1 Originalbetriebsanleitung

Vorschau ausblenden Andere Handbücher für PKGA 20-Li B1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

IE
NI
CY
• Only use chargers belonging to
the Parkside X 20 V Team series
to recharge the battery. Risk of
fire and explosion.
• Before each use, check the charg-
er, cable and plug and have them
repaired by qualified profession-
als and only with original parts.
Do not use a defective charger
and do not open it up yourself.
This ensures that the safety of the
device is maintained.
• Connect the charger only to a
socket with an earth. Ensure that
the mains voltage matches the
specifications on the charger rat-
ing plate. Risk of electric shock.
• Disconnect the charger from the
mains before closing or open-
ing connection to the battery/
power tool/device.
• Keep the charger clean and
away from wet and rain. Do
not use the charger outdoors.
Dirt and the entry of water in-
crease the risk of electric shock.
• The charger may only be
used with the corresponding
rechargeable batteries of the
Parkside X 20 V Team series.
Charging other batteries can
lead to injuries and the risk of
fire.
• Avoid mechanical damage to
the charger. This can result in
internal short circuits.
• Do not operate the charger on a
combustible surface (e.g. paper,
textiles). Risk of fire due to heat-
ing during charging.
• If the power cable for this
equipment is damaged, it must
be replaced by the manufac-
8
turer, a customer service agent
of the same or a similarly quali-
fied person in order to prevent
hazards.
• Do not use the charger to
charge non-rechargeable bat-
teries. The device could become
damaged.

Charging Process

Do not expose the battery to
extreme conditions such as
heat or impact. Risk of injury
from escaping electrolytic so-
lution! After eye/skin contact,
rinse the affected areas with
water or a neutraliser and
consult a doctor.
Charge the battery in a dry
room only.
Prior to attaching the charger,
check that the battery's outer
surface is clean and dry.
There is a risk of injury due
to electric shock.
Switch off the device and remove
the battery before carrying out any
maintenance work.
Charge the battery before the first time
of use. Do not briefly recharge the bat-
tery several times in a row.
To recharge the battery, only use a
charger belonging to the Parkside
X 20 V Team series.
If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM spare
battery available from our Customer
Service.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis