Notes On Safety - Parkside PKGA 20-Li B1 Originalbetriebsanleitung

IE NI CY
Drill diameter
for wood .......................... max. 10 mm
for steel ............................. max. 8 mm
Weight (without charger)................1.5 kg
Sound pressure level
(L ) ................... 83.7 dB(A), K
pA
Sound power level
(L ) ................. 94.7 dB(A), K
WA
Vibration (a )
h
drilling in metal .................. 1.322 m/s
idling ................................ 1.531 m/s
Motor unit with multisander
attachment .................................... PKGA2
Oscillation rate (n
0
Sanding sheet size
Weight (without charger)................1.4 kg
Sound pressure level
(L ) ................... 88.6 dB(A), K
pA
Sound power level
(L ) ................. 99.6 dB(A), K
WA
Vibration (a ) ......4.572 m/s
h
Motor unit with sabre saw
attachment .................................... PKGA3
Stroke rate (n ) .....................0-3200 min
0
Stroke length
Weight (without charger)................1.8 kg
Sound pressure level
(L ) ................... 89.3 dB(A), K
pA
Sound power level
(L ) ............... 100.3 dB(A), K
WA
Vibration (a )
h
Sawing boards ................ 12.395 m/s
Sawing wood beams ........ 12.392 m/s
Motor unit with multifunction tool ... PKGA4
Oscillation rate (n
0
Oscillation angle ..............................3.0°
Weight (without charger)................1.4 kg
6
= 3 dB
pA
= 3 dB
WA
K=1.5 m/s
) ..............0-9000 min
.......138 x 97 mm
= 3 dB
pA
= 3 dB
WA
2 , K=1.5 m/s
...................... 22 mm
= 3 dB
pA
= 3 dB
WA
K=1.5 m/s
) ............0-20000 min
Sound pressure level
(L ) ................... 84.8 dB(A), K
pA
Sound power level
(L ) ................. 95.8 dB(A), K
WA
Vibration (a ) ......4.229m/s
h
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
2 pare one power tool to another.
The stated vibration emission value may
2
2 also be used for a preliminary exposure
assessment.
Warning: The vibration emission
-1 value may differ during actual use
of the power tool from the stated
value depending on the manner in
which the power tool is used.
Try to keep the exposure to vibra-
tions as low as possible. Examples
of measures to reduce vibration
2 exposure are the wearing of gloves
when using the tool (except: operat-
ing mode drilling) and limiting the
working hours. For this purpose all
parts of the operating cycle have to
-1
be considered (for example, times
when the electric tool is switched
off and times when it is switched on
but running without any load).

Notes on Safety

2
This section details the basic safety
2
instructions for working with the
2
appliance.
-1
= 3 dB
pA
= 3 dB
WA
2 , K= 1.5 m/s 2