Switching On/Off; Motor Unit With Drill Attachment Pkga1; Choice Of Gear; Set The Direction Of Rotation - Parkside PKGA 20-Li B1 Originalbetriebsanleitung

IE NI CY
6. Check that the appliance attachment is
secure by pulling on it.

Switching on/off

1. Switching on: Press the on/off switch
( 10).
By using the on/off switch (
can progressively control the speed.
Gentle pressure: low speed
Increase pressure: higher speed.
2. Switching off: Release the on/off
switch ( 10).
If you place the direction switch
( 7) in the middle position, the de-
vice is secured against being switched
on.
Motor unit with drill
attachment PKGA1
Changing the tool
Secure the appliance against
switching on (see "Switch-
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
1. Rotate the keyless chuck (1) counter-
clockwise, until the drill chuck aperture
is large enough to accommodate the
tool.
2. Insert the tool as far as possible into
the keyless chuck (1).
3. Rotate the keyless chuck (1) clockwise
in order to clamp the tool.
4. To remove the tool again, rotate the
keyless chuck (1) and pull out the tool.
16

Choice of gear

1. Wait for the appliance to come to a
standstill.
10) you 2 Slide the gear selector (
required position:
1: low speed preselection.
2: high speed preselection.

Set the direction of rotation

The appliance's direction of rotation can
be changed with the rotational direction
switch.
1. Wait for the appliance to come to a
standstill.
2. Push the rotational direction speed
(
Clockwise rotation:
screw in screws.
Anticlockwise rotation:
screw screws.
3. If you place the direction switch
(
is secured against being switched on.

Torque adjustment

You can preselect the maximum torque.
The torque settings are labelled 1 - 19 +
1. Wait for the appliance to come to a
standstill.
2. Turn the torque adjusting ring (2) to
select the desired torque:
Screws:
Drilling:
Stop appliance before
changing gear.
7) into the desired position:
7) in the middle position, the device
The direction change may only be
actuated when at a standstill!
Steps 1 - 19
Step
3) into the
to drill and
to un-