Power Management Function - Barco AMM215WTD Benutzerhandbuch

10
User's Guide

Power Management Function

The monitor is equipped with the power management function which automatically
reduces the power consumption when not in use in three power level modes.
Stand-by Mode
•
The monitor goes into stand-by mode when the horizontal sync signal is off for
about 10 seconds. In this mode, the screen goes off and the power LED blinks
for 1 second On and 1 second Off. The screen is displayed after the horizontal
sync signal is restored.
• Suspend Mode
The monitor goes into suspend mode when the vertical sync signal is off for
about 10 seconds. The power consumption during this is 10 W. In this mode,
the screen goes off and the power LED blinks for 1 second On and 1 second
Off. The screen is displayed after the vertical sync signal is restored.
Off Mode
•
The monitor goes into power-off mode when the vertical and horizontal sync
signals are off for about 10 seconds. In this mode, the screen goes off and the
power LED blinks for 1 second On and 1 second Off. The screen is displayed
after the vertical and horizontal sync signals are restored.
Power Management System
The AMM215WTD Medical Monitor power management proposal provides four
phases of power saving modes by detecting the horizontal sync signal as shown in
the table below.
State
Horizontal Sync
Vertical Sync
Video
Power Indicator
Power
Consumption
When the monitor is power saving mode or detects an incorrect timing, the screen
will be blank and power LED indicator will blink.
Normal DPMS
Operation Standby
Active Inactive
Active Active
Active Blanked
Green Flashing (1
Green
sec. Interval)
40 W 8 W
DPMS
DPMS Off
Suspend
Active Inactive
Inactive Inactive
Blanked Blanked
Green Flashing (1 Green Flashing (1
sec. Interval) sec. Interval)
8 W 8 W