Additional Safety Instructions - Parkside PHS 160 E5 Originalbetriebsanleitung

• Do not use the power tool if the
switch does not turn it on and
off. Any power tool that cannot be
controlled with the switch is dangerous
and must be repaired.
• Disconnect the plug from the
power source and/or the bat-
tery pack from the power tool
before making any adjust-
ments, changing accessories, or
storing power tools. Such preven-
tive safety measures reduce the risk of
starting the power tool accidentaIly.
• Store idle power tools out of the
reach of children and do not al-
low persons unfamiliar with the
power tool or these instructions
to operate the power tool. Power
tools are dangerous in the hands of
untrained users.
• Maintain power tools. Check
for misalignment or binding
of moving parts, breakage of
parts and any other condition
that may affect the power tool's
operation. If damaged, have the
power tool repaired before use. Many
accidents are caused by poorly main-
tained power tools.
• Keep cutting tools sharp and
clean. Properly maintained cutting
tools with sharp cutting edges are less
Iikely to bind and are easier to control.
• Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking
into account the working condi-
tions and the work to be per-
formed. Use of the power tool for op-
erations different from those intended
could result in a hazardous situation.
• Hold the device by the insu-
lated gripping surfaces when
performing work in which the
cutting tool may come into con-
tact with hidden wiring or its
own cord. Contact with a live wire
can also cause a charge in metal parts
of the device and result in an electric
shock.
5) SERVICE
• Have your power tool serviced
by a qualiied repair person us-
ing only identical replacement
parts. This will ensure that the safety
of the power tool is maintained.

Additional safety instructions

Warning! Sanding can result
in the formation of haz-
ardous dusts (e.g. arising
from materials with paints
containing lead, materials
containing asbestos, metals
or some wood types) which
can present a hazard to the
operator or persons in the
vicinity. Make sure that the
workplace is well ventilated.
Always wear safety goggles,
safety gloves and respiratory
protection.
• Secure the workpiece. A work-
piece that is retained with clamping
appliances or a vice is held more se-
curely than with your hand.
• Only use the power tool for dry
sanding. Avoid using on damp
materials. Penetration of water into
the power tool increases the risk of
electric shock.
GB IE
23