Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
f) Do not use worn grinding discs from larger
power tools. Grinding discs for larger power
tools are not designed for the higher rotational
speeds of smaller power tools and can break.
Additional special safety instructions
for abrasive cutting
a) Avoid any blockage to the cutting disc or
high contact pressure. Do not make any
excessively deep cuts. Overloading the cutting
disc increases the stress and likelihood of tilting
or jamming and thus the possibility of kickback
or breakage of the grinding tool.
b) Avoid the area in front of and behind the
rotating cutting disc. When you move the cutting
disc away from yourself in the workpiece, it is
possible, in the event of a kickback, that the
power tool along with the rotating disc might be
thrown out directly towards you.
b) If the cutting disc jams or you stop working,
switch the tool off and hold it steadily in the
workpiece until the disc has completely
stopped turning. Never attempt to pull a
rotating cutting disc out of a cut. This could
lead to kickback. Identify and remove the
cause of the jam.
d) Do not switch the power tool back on while it
is located in the workpiece. Allow the cutting
disc to reach its full speed before you care-
fully continue the cut. Otherwise, the disc can
jam, jump out of the workpiece or cause kick-
back.
e) Support boards or large workpieces to reduce
the risk of the cutting disc jamming and
causing a kickback. Large workpieces can bend
under their own weight. The workpiece must be
supported on both sides of the disc: both in the
vicinity of the cutting disc and also at the edge.
f) Be particularly careful when making pocket
cuts into existing walls or other obscured
areas. The inserted cutting disc may cut into gas
or water pipes, electrical wiring or other objects
that can cause kickback.
│
GB │ IE
■
8
Safety guidelines for battery
chargers
This appliance may be used by
■
children aged 8 years and above
and by persons with limited phys-
ical, sensory or mental capabili-
ties or lack of experience and
knowledge, provided that they
are under supervision or have
been told how to use the appli-
ance safely and are aware of
the potential risks. Do not allow
children to use the appliance as
a toy. Cleaning and user mainte-
nance tasks may not be carried
out by children unless they are
supervised.
To avoid potential risks, damaged
■
mains cables should be replaced
by the manufacturer, their
customer service department or
a similarly qualified person.
The charger is suitable for indoor use only.
WARNING!
■
To avoid potential risks, damaged mains
cables should be replaced by the manufac-
turer, their customer service department or a
similarly qualified person.
ATTENTION!
♦
This charger can only charge the following
batteries: PAP 20 A1/PAP 20 A2/
PAP 20 A3/PAP 20 B1/PAP 20 B3/
PAPS 204 A1/PAPS 208 A1.
♦
A current list of battery compatibility can be
found at www.lidl.de/Akku.
PWSA 20-Li E4
Werbung
Inhaltsverzeichnis
