Sanding; Selection Of Sanding Sheet; Choosing The Right Sanding Plate; Cleaning/Maintenance - Parkside PHS 160 E5 Originalbetriebsanleitung

Pull the mains plug before any ad-
justments, maintenance or repair.
Danger of electric shock.

Sanding

• Move the appliance against the work-
piece once it is switched on.
• After machining, lift the sanding disc
up before turning off the device.
• Always lead the mains cable towards
the back and away from the device.
• Clean the sanding plate before you at-
tach a sanding sheet.
• Only work with sanding sheets in per-
fect condition to achieve good sanding
results.
• Work with low and even pressure and
even forward pressure. This protects
the appliance and the sanding sheet.
• Grind rough corners and edges with
the top or side edge of the sanding
sheet.
If the front tip of the triangular sanding
sheet is worn, the sanding sheet can
be removed, rotated and put back into
place.
• Do not use the same sanding sheet to
sand different materials (e.g. metal
and then wood).
• Empty the dust collection box or the
vacuum cleaner regularly in order to
ensure optimal suction.

Selection of sanding sheet

Grain size Application
P 60 for pre-sanding rough wood
P 80 surfaces
P 120
for plain sanding
P 180
for ine sanding of primed and
P 240
painted surfaces
Choosing the right sanding
plate
Pre-mounted sanding plate:
• For sanding/grinding large surfaces
as well as corners, edges and outer
curves.
Sanding inger:
• For machining small slots and narrow
intermediate spaces.

Cleaning/Maintenance

Pull the mains plug before any ad-
justments, maintenance or repair.
Repair and servicing work not
described in this manual should
always be carried by our Service
Centre. Use only original parts.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.
GB IE
27