Operation - Ribimex Ribiland PR4EN1T Bedienungs- Und Wartungsanleitung

5. Wipe up any spilled fuel from the powerhead before restarting
WARNING!
• Always minimize the risk of fire when handling fuel!
• Always allow the product to cool before refueling!
• Wipe all spilled fuel and move the product at lease 3 meters (10 feet) from the fueling point
before restarting!
• Never smoke or light any fires near the product or fuels!
• Never place any flammable material near the engine muffler!
• Never operate the engine without the muffler and spark arrestor in place and properly
functioning!
• Never operate this machine if fuel system components are damaged or are leaking.
V. OPERATION
5.1- Starting a cold engine – Restarting after refueling
5.1.1- Control positions - cold engine
1. Set the throttle trigger to "fast idle" as follows (Fig.E9)
• Depress and hold the throttle lockout lever
• Squeeze and hold the throttle trigger.
• Depress the throttle lock button.
• While holding down the throttle lock button, release the throttle trigger and throttle lockout
lever.
• Release the throttle lock button
2. Slide the ignition switch to the "I" (start) Position. See Fig.E10
3. Prime the engine by depressing the carburetor primer bulb four or five times. See Fig.E11
You should be able to see fuel inside the bulb.
4. Choke the engine by moving the choke lever up to the "closed" position. See Fig.E12.
Fig. E9
Fig.E11
1. Primer bulb
2. Return tube
Important! Engine ignition is controlled by a two-position START-STOP switch mounted on the
Fig.E9
1. Ignition Switch
2. Throttle lock button
3. Throttle lockout lever
4. Throttle trigger
Fig.E12
1. Chock lever closed position
Fig.E10