Ribimex Ribiland PR4EN1T Bedienungs- Und Wartungsanleitung Seite 51

1. Grip the handles of the brush cutter firmly with both hands.
If you suspend the work, place the throttle into the idling position.
2. Always be sure to maintain a steady, even posture while working,
3. Maintain the speed of the engine at the level required to perform cutting work, and never raise the
speed of the engine above the level necessary.
4. If the grass gets caught in the blade during operation, or if you need to check the unit or refuel the
tank, always be sure to turn off the engine.
5. If the blade touches a hard object like a stone, immediately stop the engine and check if something
is wrong with the blade. If so, replace the blade by new one.
6. If someone calls out white working, always be sure to turn off the engine
before turning around
7. Never touch the spark plug or plug cord while the engine is in operation.
Doing so may result in being subjected to an electrical shock.
8. Never touch the muffler, spark plug, or other metallic parts of the engine
white the engine is in operation or immediately after shutting down the
engine. Doing so may result in serious burns.
9. When you finish cutting in one location and wish to continue work in another spot, turn off the
engine and turn the unit with the blade facing away from your body.
3.3.9- Maintenance safety precaution
1. Perform the maintenance and checking operations described in this manual at regular intervals, if
any part must be replaced or any maintenance or repair work not described in this manual must be
performed, please contact the nearest authorized servicing dealer for assistance.
2. Under no circumstances should you ever take apart the brush cutter or alter it in any way. Doing so
might result in the brush cutter becoming damaged during operation or the brush cutter becoming
unable to operate properly.
3. Always be sure to turn off the engine before performing any maintenance or checking procedures.
4. When sharpening, removing, or reattaching the blade, proper tools and equipment are required to
prevent injury.
5. When replacing blade or any other part or when replacing the oil or any lubricant, always be sure to
use products or products which have been certified for use with the brush cutter.
IV. GETTING STARTED
4- Set Up
4.1- Accessory
Insert the lower tube (10) into the handle C tube until the gear aligns and align the positioning holes
on the tube. Ensure assembly is tight and secure.
4.2- Install the gearcase
1. Loosen two clamp screws and remove one index screw.
2. Push the pipe towards gearcase and rotate it by hand to check that
the main shaft splines engage the powerhead.
3. Insert the pipe into gearcase until its bottoms align the positioning
holes on the pipe and gearcase,
4. Then replace the index screw and tighten.
5. Fasten the pipe clamp securely with two clamp screws. See
Fig.BC3
Fig.BC3
1. Clamp screws
2. Index screw