Ribimex Ribiland PR4EN1T Bedienungs- Und Wartungsanleitung Seite 65

4.2.2- Cutter assembly for desired cutting angles
WARNING! Do not touch the cutter blades when the engine
is running. The blades can oscillate even if the
engine is idling.
The cutter assembly can be adjusted to 10 different positions
ranging from 120° to 270° from the outer tube as shown in
Fig.HT8. Refer to the steps on the previous page for the
adjustment procedures. Always make sure the lock latch is
securely locked after each adjustment
4.2.3- Cutter assembly for storage or transportation
WARNING! Never run the engine when adjusting the cutter
assembly to the storage position
1. With the engine stopped, install the cover onto the blade.
2. Using the procedures described on the previous page, rotate
the cutter assembly so it is parallel to the tube.
Make sure the latch lock and the latch release return securely to
a locking position. See Fig.HT9
3. Make sure the cover is in place on the cutters before storing
or transporting
4.3- Wearing the Strap
1. Hook the strap hook to the hanger on the outer pipe.
2. Wear the strap so that the hook stays at your right hand side.
3. Adjust the length of the strap so that you can hold and operate the machine comfortably.
4.4- Preparations
1. Wear suitable protective clothing and equipment-see section "Safety Precautions".
2. Choose the best work position for safety against the falling object (Branch etc)
3. Start the engine,
4. Put on the strap.
5. Never stand directly underneath the branch you are cutting-be wary of failing branches.
Note that a branch may spring back at you after it hits the ground.
V. OPERATION
5.1- Intended use
- The product is intended for domestic use.
- The product is intended for trimming hedges
5.2- Cutting sequence
If a radial cut is necessary, cut a little at a time in several passes.
5.3- Working position
Hold the control handle with your right hand, and the shaft with your left hand.
Your left arm should be extended to the most comfortable position.
NOTE: Take a rest when you feel fatigue
5.4- Preparations
Use lopping shears to cut out thick branches first.
Fig.HT8
Fig.HT9
1. Gear case rotated to the storage /
transportation position