Ribimex Ribiland PR4EN1T Bedienungs- Und Wartungsanleitung Seite 66

5.5- Cutting techniques (Fig.HT10; 11; 12; 13)
5.5.1- Vertical cut:
Swing the cutting blade up and down in an arc as you move along the hedge; use both sides of the
cutting blade.
5.5.2- Horizontal cut:
Hold the cutting blade at an angle of 0° to 10" as you swing the hedge trimmer horizontally.
Swing the blade in an arc towards the outside of the hedge so that the cuttings are swept on to the
ground.
Fig.HT10
Horizontal cut: cutting close to ground from
standing position (e.g. low shrubs)
Fig.HT12
Vertical cut: cutting without standing directly
next to hedge (e.g. flowerbed between operator
and hedge)
VI. MAINTENANCE
6.1- Daily maintenance
WARNING! Always wear gloves when working around the cutter assembly.
1. Clean any debris or dirt from the hedge trimmer cutter blades.
Lubricate the blades before use and after refueling.
Check the cutters for damage or incorrect adjustment.
2. Check for loose or missing screws or components.
Make sure the cutter attachment is securely fastened.
3. Check the entire machine for leaking fuel or grease.
4. Make sure the nuts, bolts, and screws (except carburetor adjusting screws) are tight.
WARNING! Before performing any maintenance, repair, or cleaning work on the unit, make sure
Fig.HT11
Horizontal cut: cutting without standing directly
in front of the hedge (e.g. reaching over a
flowerbed)
Fig.HT13
Overhead cut: hold the shaft upright with a 90 °
blade angle to cut upper surface of hedge.