Ribimex Ribiland PR4EN1T Bedienungs- Und Wartungsanleitung Seite 52

4.3- Safety guard
Attach the safety guard to the gear case and fix it with the clamp and 2 bolts (M5*25) securely (see
Fig.BC4)
Fig.BC4
4.4- Installing the metal blade (Fig.BC5)
1. Set the inner holder to the gear shaft, and turn to fix with the attached L-shaped bar (hex-key).
2. Put the blade on the inner holder with letters to the gear case, and match correctly the hole of the
blade to the projection of the inner holder.
3. Set the outer holder to the gear shaft with the hollowed face to the blade.
4. Put the attached bolt cover on the outer holder and secure it with the bolt (left screw) together with
the spring washer
4.5- Installing the nylon wire spool (Fig.BC6)
1. Set correctly the inner holder and the outer holder to the gear shaft
2. Screw the attached bolt (M8 left) into the gear shaft and secure it with the spanner
3. Screw the nylon cutter spool into the bolt by fixing the inner holder with the L-shaped (hex-key)
bar and tighten it manually.
NOTE: Keep bolls and washers to install the blade carefully so as not to lose them.
Fig.BC5
4.6- Wearing the Strap (Fig. BC7)
1. Hook the strap hook to hanger on the outer pipe.
2. Wear the strap so that the hook stays at your right hand side.
3. Adjust the length of the strap so that you can hold and operate machine
comfortably.
Fig.BC4
1. Bolt
2. Clamp
3. Main pipe
4. Safety guard
Fig.BC5
1. Nut
2. Outer holder 1
3. Outer holder 2
4. Blade
5. Gear shaft
6. Bar (hex-key)
7. Inner holder
8. Gear case
Fig.BC6
1. Strap
Fig.BC6
1. Gear case
2. Bolt
3. Nylon cutter
spool
4. Nylon wire
Fig.BC7