Operation - Ribimex RIBILAND PRBAT20 Bedienungs- Und Wartungsanleitung

V. OPERATION
5.1- Intended use
- The product is intended for outdoor domestic use in private gardens/property.
- The tool is only suitable for blowing dry leaves, grass ... within the limits of its characteristics.
- Do not use the machine for applications not described in this manual.
- Do not use the machine for unsuitable purposes (for ex. blowing fire, flammable or explosive
material, ...). Do NOT operate on damp or wet working area.
- The tool is not intended for artisanal, commercial, professional and/or industrial use (for ex.: in
public parks...).

5.2- Operation

Before any operation:
-- always visually inspect that the product does not show signs of use or damage
-- check that the screws, bolts and nuts are well tightened.
-- replace any used or damaged part, and tighten firmly the screws, bolts and nuts when needed.
Important - Before starting work:
- Repeat several times the starting and stoppage of the machine to become familiar with it.
- Make trial work on small area to become familiar with handling the machine.
1. Ensure that battery is charged, otherwise proceed with charging.
2. Wear appropriate protective equipment.
3. Clear working area off any objects likely to pose a hazard.
4. Inform persons to stay away from working area and machine while you are working.
5. Firmly hold tool with hand, and always maintain a balanced and secure position.
6. Place air outlet (1) above the working area. Do not make sudden movements.
7. Push switch (6) to "I" to start operation.
8. Start operating on working area with slow left-to-right movement, working through small areas at
a time. Do not make sudden movements.
9. Never work on wet or very damp grass / materials.
10. Once work is finished, stop product by pulling the switch (6) to "0" position.
ATTENTION! Do not assume of your knowledge of the tool.
DO not be filled (over repeated use) with a sense of ease and familiarity with the tool, neglecting
strict compliance to the safety instructions given with the tool.
Improper use of the tool or failure to comply with the provided safety instructions in this manual can
cause severe injury.
Remember that a split second of negligence is enough to cause serious damage.
Remain alert about your surroundings and especially for any danger that you may not hear while
using the tool.
5.3- Tips for using the blower
The following points may assist you in the operation of the tool:
- Always try to blow dry leaves, cuttings or general garden debris.
Wet materials are difficult to work with and also can cause the blower to clog.
- Avoid using the blower on areas where there are stones, or other hard objects.
These objects may be projected and cause injury or damage to property.
Page 27 / 75