Installing Arm Type Magnets - Pioneer SGY-PM910H Bedienungsanleitung

Installing Arm Type Magnets

This section explains how to install arm type magnets (temporarily).
The left side of the bicycle is used as an example for this explanation, but the right side uses the same procedure.
• The position of the arm type magnets must be checked periodically.
• The left and right side arm type magnets have different shapes. They do not operate correctly if they are installed reversed left to right.
Right side
Left side
1
Attach the cushion provided to the magnet's arm.
Remove the non-adhesive backing paper from the cushion and stick it to the base of the arm (the part that touches the
chain stay).
2
Rotate the crank set to confirm the position the magnetic sensor passes over.
The position to install the magnets is along the circle around which the magnetic sensors pass.
3
Temporarily install the magnet on the chain stay.
Use the cable ties provided to install the magnet on the chain stay so it is positioned on the circle confirmed in step 2.
• You need to adjust the position of the magnets to confirm their operation, so do not tighten the cable ties too much.
EN
Installing the Magnets
13