Herunterladen Inhalt Inhalt Diese Seite drucken

Installing Patch Type Magnets - Pioneer SGY-PM910H Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für SGY-PM910H:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

Installing Patch Type Magnets

This section explains how to Install patch type magnets (temporarily).
The left crank is used as an example for this explanation, but the right crank uses the same procedure.
Do not remove the non-adhesive backing paper from the back of the magnet at this time.
If the position in which you will install the patch type magnet is dirty, remove any dirt with cleaner before you install it.
The patch type magnets can also be installed on the seat tube. If you install the patch type magnet on the seat tube, confirm that the
position and results of the measurement are as shown below.
-
Right side: Distance between chainring adapter and seat tube: Between 4.5 mm and 9.1 mm
-
Left side: Distance between left transmitter and seat tube: Between 4.5 mm and 13.7 mm
The procedure to install the magnet on the seat tube is basically the same as installing it on the chain stay. However, if you install the
magnet on the seat tube, be careful of its orientation. Install the magnets so their long sides align with the circle along which the magnetic
sensors pass.
Installed on chain stay
1
Apply masking tape to temporarily hold the magnet.
2
Rotate the crank set to confirm the position the magnetic sensor passes over.
The position to install the magnets is along the circle around which the magnetic sensors pass.
Installed on seat tube
EN
Installing the Magnets
11

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis