Pioneer SGY-PM910H Bedienungsanleitung Seite 8

EN
Checking Operation of the Sensors
5
Push the push switch in the right transmitter for less than 2 seconds to confirm the sensor mode is set
to the pedaling monitor mode.
By pushing the push switch in the right transmitter for less than 2 seconds, the LEDs on the right transmitter blink green.
After that, if the LEDs light green for 10 seconds, the sensor is set to pedaling monitor mode.
Left side
Push switch
LED
If the LEDs light orange for 10 seconds, the sensor is set to power meter mode.
By pushing the push switch in the right transmitter for more than 2 seconds, the LEDs on the right transmitter blink green.
After confirming the blink, release the push switch. When the blinking stops, the LEDs on the left and right transmitters light
green for 10 seconds and the sensor mode changes to pedaling monitor mode.
• If the pairing between the left and right transmitters fails, the LEDs blink red 5 times.
• Please do not push the push switch for more than 5 seconds. Doing so changes the mode to calibrate the magnet position.
• It may take about 10 seconds to switch the sensor mode depending on the radio transmission conditions.
6
Install the right transmitter cover.
Use a tool that can measure the torque to tighten the screws.
• Tightening torque: 30 cN•m
• Install the cover firmly to ensure water resistant performance.
8
Right side