EN
Pairing the Pedaling Monitor Sensor
5
Tap [Device Type] and then [Pedaling Monitor R].
A list appears when you tap [Device Type]. Scroll down the list and then tap [Pedaling Monitor R].
•
For the left pedaling monitor sensor, press [Pedaling Monitor L].
6
Tap [Search].
A [Searching. Please wait.] message appears. The information about the sensor appears when the sensor is found.
7
Check the information about the sensor.
The pairing is successful if the transmitters' device numbers and the number in [Device Number] match and if "OK" appears
in [Error Rate].
•
See page 22 regarding the device numbers of the transmitters.
•
If "Processing..." appears in [Error Rate], the information from the sensor is not being received correctly because transmission conditions
are bad. Make sure that the sensor you are pairing is activated, then bring the SGX-CA500 closer to the sensor and do the pairing
operation again.
•
Pairing may fail because of interference in the 2.4 GHz band. If "Processing..." appears even while holding the sensor near the SGX-
CA500 during pairing, try pairing it again in a location separated from any microwave ovens, wireless LAN, Wi-Fi, or other interference.
You may not be able to pair the sensor you want to pair if multiple sensors are activated. If this is the case, bring the SGX-
CA500 closer to the sensor you want to pair, or specify the device number. (page 21)
20