Installing And Removing The Batteries/Switching Modes - Pioneer SGY-PM900H90 Benutzerhandbuch

Installing and Removing the Batteries/
Switching Modes
You must install the batteries before using the product.
You can change the sensor modes after installing the batteries.
• The product can be used as the ANT+ Power meter with the cyclocomputers of other
companies (power meter mode).
To use the product in power meter mode, insert the battery in the right-side part first,
and then the left-side part.
1. Loosen the screws on the
transmitter and remove its
cover.
Use a philips screwdriver to loosen the
screw and remove the cover.
• Be careful not to lose the removed
screw.
• Right transmitter (screws: 3 x)
• Left transmitter (screws: 4 x)
2. Remove the old battery.
• Right transmitter
EN
7