Before Pairing and Calibrating
EN
This section describes how to pair and calibrate the pedaling monitor sensor that is installed on the bicycle to the Cyclocomputer
SGX-CA500.
•
See the User's Manual or the User's Guide (online manual) of the Cyclocomputer SGX-CA500 regarding how to operate it.
Pairing and Calibrating Procedure
Use the following procedure to pair and calibrate the product.
1.
Placing the bicycle in a secure work position (page 18)
2.
Pairing the pedaling monitor sensor (page 19)
3.
Calibrating the zero point (page 23)
4.
Checking the calibration (page 24)
Placing the Bicycle in a Secure Work Position
Place the bicycle in a level location, such as on a repair stand or indoor trainer.
Be sure to secure it so that it will not fall while you are working.
Install the right crank to the frame, and then confirm that the crank is not tilted to the left or right by pressing the level onto the
end of the crankshaft.
After that, install the left crank.
•
Tightening torque: 12 N•m
18