Pioneer SGY-PM910H Bedienungsanleitung Seite 10

EN
Installing the Magnets
3
Select a type of magnet according to the following table.
Crank
Distance between chainring adapter and chain stay
Right
Distance between left transmitter and chain stay
Left
*1 The chainring adapter and the arm type magnet must be installed so the distance between them is under 5.0 mm.
*2 The left transmitter and the arm type magnet must be installed so the distance between them is under 9.6 mm.
• The patch type magnet may not be installable, depending on the shape of the chain stay. If this is the case, install the patch type magnet
on the seat tube, or choose the arm type magnet.
• If you install the patch type magnet on the seat tube, confirm that the position and results of the measurement are as shown below.
-
Right side: Distance between chainring adapter and seat tube: Between 4.5 mm and 9.1 mm
-
Left side: Distance between left transmitter and seat tube: Between 4.5 mm and 13.7 mm
10
Position to measure Measured results Type of magnet
Over 4.5 mm
Patch type
Under 9.1 mm
Over 1.5 mm Arm type
Over 4.5 mm
Patch type
Under 13.7 mm
Over 1.5 mm Arm type
(*1)
(*2)