Herunterladen Inhalt Inhalt Diese Seite drucken

Pairing The Pedaling Monitor Sensor - Pioneer SGY-PM910H Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für SGY-PM910H:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

Pairing the Pedaling Monitor Sensor

This section describes how to pair the pedaling monitor sensor to the Cyclocomputer SGX-CA500.
It is necessary to pair the sensors on both the left and right sides. The right-side pedaling monitor sensor is used as an example
in this description. The procedure to pair the left side is the same as for the right side.
1
Check that the right transmitter and the left transmitter are in "Pedaling monitor mode".
See page 7 to switch the modes.
2
Rotate the bicycle's crank set more than three rotations to start the left and right transmitters.
You have only 5 minutes to pair to the Cyclocomputer. If the transmitter stops while you are pairing, turn the crank set one revolution to
start the transmitter and continue the pairing.
3
Press the [MENU] button on the SGX-CA500 and then tap [Sensors].
4
Tap [Connect New].
EN
19

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis