Schleicher XCx 1200 series Betriebsanleitung Seite 103

Die SPS
Section CANxx
; CAN parameter Definitionen:
; Achtung: Überschreibt etwaige Einstellungen in der CANconf.dat!!
[CAN00] ; e.g. card# 0
; any description
DESCRIPTION
NODE_ID
; baudrate
; (1=10,2=20,3=50 obsolet),4=125,5=250,6=500,7=800,8=1000 MBit/s
BAUDRATE
BOOTUP_DELAY
CYCLE_TIME
Section sercos
[sercos]
; default IP Address for NRT communication
sercos_IP=192.168.0.1
Section DPxx
; DP parameter Definitionen:
[DP00]
USE_COM_DRV
; any description
DESCRIPTION
BUS_ADDR
MASTER_FCONF
configuration,
FirmwareFileFolder ="/ata0/OS/DP/"
terminated
Section IODriver (CIF Driver für DPM Karten)
(s. ProConOS Manual for Hilscher CIF 30/50 and ProConOS CIF Driver Manual
for Hilscher fieldbus CIF interfaces)
[IODriver]
; The 0 at the end of the parameter name characterises the first of n
possible
; further drivers IODriver[n]. The name refers to the current version of the
; driver. Thus in future versions only this place has to be changed but not
the
; user projects (see I/O configuration).
IODriver0
[CIF_KW_V2.0@0]
; If this key is set, the hardware communication
stopped
; manually by the user. Specific function blocks are provided for this
purpose.
; Otherwise the driver will start the hardware communication at PLC_RUN and
; stop the hardware communication at PLC_STOP automatically.
StartUpManual
; If this key is set, the Hilscher configuration tool SyCon is able to
connect to
; and to configure installed CIF boards via TCP/IP. The TCP/IP address is
the
; same as of ProConOS. This key can only be set in the section of the first
CIF
; board.
ComServer
Betriebsanleitung XCx 1100 / XCx 1200 ● Version 01/14
= CANconf #0 (XCx 500 series)
= 1 ; bus address, 1..127
= 4
= 0 ; bootup delay, 0..60 s
= 4 ; CAN cycle time, 0..255 ms
; e.g. card# 0
= 1
; 1 = yes (default), 0 = no
= Profibus DPS #0 (XCx5 series)
= 2
= 1
; no further configuration necessary
; 1 = yes (default)/ 0 = no
; with "/" (for automated updates)
; Name of section
= "CIF_KW_V2.0"
; One instance for one CIF board.
= 0
= 0
; use the simple COM slave driver,
; 0..126
; the master force slaves
; location of the firmware file
must be started and
103