Cleaning And Maintenance; Cleaning; General Maintenance - Parkside PDOS 200 B2 Originalbetriebsanleitung

Unscrewing the left-hand nut (left-
hand thread): turn clockwise.
Unscrewing the right-hand nut
(right-hand thread):
turn anticlockwise.
3
(10b) and the grinding disc (10).
4. Set up the new grinding disc (10)
with the intermediate shims (10c)
made of cardboard and the clam-
screw the grinding disc nut (10a)
on.
Screwing the left-hand nut (left-
hand thread) on:
turn anticlockwise.
Screwing the right-hand nut
(right-hand thread) on:
turn clockwise.
5. Screw the left hand and right
hand grinding disc covers (8) on.
6. Adjust the spark protection (
and the workpiece support
( 11) - the distance to the grin-
(see „Assembly")
The grinding disc nut must not be
screwed too tightly in order to
avoid a breaking of the grinding
disc and nut.
7. Test run:
Before starting work and after each
change of grinding disc, carry out a
test run of at least 60 seconds with no
load. Switch off the equipment immedi-
ately if the disc runs lumpy, substantial
vibrations occur, or abnormal noises
are generated.
0
0 2
Cleaning and
maintenance
Disconnect the plug before adjust-
ment, maintenance or repair.
Have any work not described
in these instructions carried
out by a specialist workshop.
Use only original compo-
nents. Allow the equipment
to cool before carrying out
any maintenance and clean-
ing work. There is a risk of
burns.

Cleaning

Do not use cleaning agents or sol-
vents. Chemical substances may at-
tack plastic parts of the equipment.
1)
Never clean the equipment
under running water. WARN-
ING! Electric shock hazard.
• Clean the equipment thoroughly after
each use.
• Clean the surface of the equipment
with a brush or cloth.

General maintenance

Before each use, check the equipment
for obvious defects such as loose, worn
or damaged components and check that
screws or other parts are sitting correctly.
In particular, check the grinding
disc ( 10). Replace damaged parts.
G B I E
2 9