Assembly; Assemble/Adjust Spark Protection; Assemble/Set Workpiece Supports - Parkside PDOS 200 B2 Originalbetriebsanleitung

G B I E
tionality of active or passive medical
implants. To reduce the risk of seri-
ous or lethal injuries, we recommend
that persons with medical implants
consult their doctor and the manu-
facturer of their medical implant
before operating the machine.

Assembly

Caution! Risk of injury!
space in which to work, and that
you do not endanger other peo-
ple.
- Always fasten the device on to
the work surface with screws
thickness in order to maintain
control of the device.
- All covers and protective devices
must be assembled properly be-
fore commissioning.
- Disconnect the mains plug before
changing the setting on the de-
vice.
Figure and Figure
workpiece support on the left-hand
side of the device. Fit the second
spark protection and the second
workpiece support
Assemble/adjust spark
protection
spanner (size 8 mm) (sold separate-
the above.
2 6
show
Assemble/set workpiece sup-
ports
1. Screw the spark protection (1) to
the spark protection holder (2). To
nut (4a), spring washer (4b) and
washer (4c) supplied.
2. Fit the second spark protection in
a similar manner.
3. Screw the spark protection holder
(5). To do this, use 1 adjusting
screw including the spring washer
for each.
4. Adjust the spark protection (1)
with the adjusting screw (3) - the
distance between the grinding
disc (10) and the spark protection
2
image).
Periodically readjust the spark pro-
tection in order to offset the wear
and tear of the grinding disc (dis-
2
Despite the spark protection, you
should always wear safety glasses
when working in order to avoid eye
injuries.
1. Screw the workpiece supports
(11) on to the device.
2. To do this, use the screw (12a),
washer (12b), toothed washer
(12c) and star nut (12) supplied.
3. Set the workpiece support (11) of
the grinding disc with the star grip
nut (12) so that the distance be-
tween the grinding disc (10) and
mm (see small image).
4
3 3
2