General Safety Instructions; Safe Operation - Parkside PDOS 200 B2 Originalbetriebsanleitung

Wear anti-slip safety shoes.
Never use faulty grinding discs.
Do not dispose of electrical equip-
ment in household waste.
Dimensions grinding disc

General safety instructions

The term "power tool" used in the safety
instructions refers to mains-operated electric
tools (with a mains cable) and to battery-op-
erated electric tools (without a mains cable).

Safe operation:

Keep work area clear. Cluttered
•
areas and benches invite injuries.
Consider work area environ-
•
ment.
- Do not use tools in damp or wet loca-
tions.
Water entering a power tool will in-
crease the risk of electric shock.
- Keep work area well lit.
- Do not use tools in the presence of
Power tools create sparks which may
ignite the dust or fumes.
Guard against electric shock.
•
Avoid body contact with earthed or
grounded surfaces (e.g. pipes, radia-
tors, ranges, refrigerators).
Keep other persons away.
•
Do not let persons, especially children,
not involved in the work touch the tool
away from the work area.
Store idle tools. When not in use,
•
tools should be stored in a dry locked-
up place, out of reach of children.
Do not force the tool. It will do
•
the job better and safer at the rate for
which it was intended.
Use the right tool.
•
- Do not force small tools to do the job
of a heavy duty tool.
- Do not use tools for purposes not
cular saws to cut tree limbs or logs.
Use of the power tool for operations
different from those intended could re-
sult in a hazardous situation.
Dress properly.
•
- Do not wear loose clothing or jewellery,
they can be caught in moving parts.
- Anti-slip footwear is recommended
when working outdoors.
- Wear protective hair covering to con-
tain long hair.
Use protective equipment.
•
- Use safety glasses.
- Use face or dust mask if working op-
erations create dust.
Connect dust extraction equip-
•
ment. If the tool is provided for the
lecting equipment, ensure these are
connected and properly used.
Do not abuse the cord. Never
•
yank the cord do disconnect it from the
socket. Keep the cord away from heat,
oil and sham edges.
Secure work. Where possible use
•
clamps or a vice to hold the work. It is
safer than using your hand.
Do not overreach. Keep proper
•
footing and balance at all times.
This enables better control of the pow-
Maintain tools with care.
•
Many accidents are caused by poorly
maintained power tools.
- Keep cutting tools sharp and clean
for better and safer performance.
G B I E
2 3