Chronograph, Automatic Winding Models - Georg Jensen C30-ST01 Bedienungsanleitungen

Operating Instructions: Mechanical Watches
Chronograph, automatic winding
Models : D42-ST71, D46-ST71, K41-ST71, S42-ST71, S46-ST71
F
A 60
30
25
C
40 20 20
15
12
10 2
H
8 4
Setting the time:
1. P ull the crown out to position 3, its maximum extension. The second hand (C) will stop moving.
2. T urn the crown either clockwise or anti-clockwise until the watch hands (A and B) are positioned at
the desired time.
3. W hen the desired time is reached push the crown back to position 1 and screw down if applicable.
NOTE: When the hour hand passes 12 o'clock, the watch is set at midnight if the date changes. If the
date does not change, it is set at noon.
Display & control buttons
I
A : Hour hand
B B : Minute Hand
1 2 3
5 C : Second Hand
D : Date window
F : Centre stop second
G
G : 30-minute counter
H : 12 hour counter
J
I : start / stop pusher
D J : re-set pusher
1 9
Setting the date:
1. Pull the crown out to position.
2. Turn the crown clockwise until the desired date appears in the date window (D).
3. When the desired date is reached push the crown back to position 1 and screw down if applicable.
NOTE: Do not change the date between 10pm and 2am as this may damage the movement.
Chronograph: Basic Functions (Start, Stop & Reset):
1. To start timing, press the start stop pusher (I)
2. To stop timing, press the start / stop pusher (I) again
3. Elapsed time can be read as follows: hours: 12 hour counter (H)/minutes: 30-minute counter
(G)/seconds: second stop hand (F)
4. To reset, press the reset pusher (J)
Chronograph: Accumulated Timing:
1. To start timing, press the start stop pusher (I)
2. To stop timing, press the start / stop pusher (I) again
3. To resume timing, press the start/stop pusher (I) again
4. To stop timing, press the start / stop pusher (I) again
5. Elapsed time can be read as follows: hours: 12 hour counter (H)/minutes: 30-minute counter
(G)/seconds: second stop hand (F)
6. To reset, press the reset pusher (J)
NOTE: accumulated timing sessions can be continued by repeating steps 2 and 3 above
2 0