Calibration Accessories - Dräger X-am 7000 Gebrauchsanweisung

Designation
For operation in pumped mode:
Telescopic probe 150 stainless steel
Pump membrane set
Water and dust filter
Evaluation accessories:
"GasVision" PC program
IrDA interface for PC
Dräger CC Vision PC software

Calibration accessories

BumpTest Station, Dräger X-am 7000
Set sensor extension cable
for steam calibration
E-Cal module
Calibration cylinder
Adapter, for calibration cylinder
Hand pump
For further calibration accessories:
see data sheets for the installed sensors
Dräger X-am 7000
Order no.
Designation
PID sensor accessories
83 16 533 Spare bulb
83 18 607 Cleaning kit
83 13 648 The accessories below are covered in the approvals
BVS 03 ATEX E 371 X and PFG-No. 41300404.
Calibration adapter Dräger X-am 7000
83 14 034
for calibration with test gas cylinder
64 08 140
Pump adapter
Freeware
Leak probe 70
Tester 90
83 18 909
Telescopic probe 100
83 17 970
Float probe set
Hose for floating probe, electrically conductive,
83 17 705
by the metre (not suitable for use with H
68 03 407
Fluororubber hose (suitable for use with H
68 04 620
1) Because of a limited storage time, we recommend that you order only for
68 01 933
your current needs.
Order List
Order no.
83 19 110
83 19 111
83 17 656
83 17 639
83 16 531
83 16 532
83 16 530
83 18 371
11 80 681
S)
2
S) 12 03 150
2
59