Powering On The Cash Register - Olivetti NETTUN@7000int'l Anwenderhandbuch

POWERING ON THE CASH REGISTER

To power on the cash register, you must first connect the power unit to the cash
register as described previously, then press the
switches the cash register on, after a brief interval the sales environment is displayed
and the cash register is ready for operation.
When the cash register is powered on (
pressing the
if no operations are in progress.
If, during the power off phase, the cash register is found to be in an operational state
that does not consent powering off, a notification message is displayed warning the
user that powering off is not allowed.
In this case, the user must first terminate the operational procedure in course, and
then press the
register.
WARNING: if the cash register is not used for a certain length of time, it
automatically enters energy saving mode: the touch screen is
powered off, while the
Touching the touch screen at any point returns the register to
operation mode and you can proceed to use it again.
1-4
key again for approximately 5 seconds. The power off phase starts
key again (for approximately 5 seconds) to powering off the cash
key. Pressing the
key lighted), it can be switched off by
key remains illuminated.
Power button
key