Inserting Paper; Safety Precautions And General Standards Of Use - Olivetti NETTUN@7000int'l Anwenderhandbuch

INSERTING PAPER

WARNING: Only Mitsubishi F5041 thermal paper must be on the cash register.
Different types of thermal paper, especially paper that is too thin,
could result in incorrect advancement of the ticket. The writing
and logos on the back of the ticket also must not be visible on the
front due to the transparency of the paper.

SAFETY PRECAUTIONS AND GENERAL STANDARDS OF USE

Note: before starting to use the product, read this section attentively.
Make sure that the electrical specifications for the cash register power unit (230 V
AC, 50/60 Hz) correspond with those of the mains power supply
Connect the cash register to a standard electrical installation
Do not expose the printer to direct sunlight, or install it near sources of heat or
water, or in environments that are very dusty or humid.
Should smoke, odours or unusual noises issue from the register, disconnect it
from the mains supply and contact the Technical Services desk.
To avoid risk of injury, do not touch the parts indicated in the figure:
Cutter counterblade:
very sharp
Do not pull the paper from the output slot with the cash register cover closed.
Do not open the register cover while it is printing.
Do not carry out any interventions on the cash register apart from the procedures
indicated here for problem resolution.
Do not attempt to disassemble or modify the product.
Note: The procedures described below can be followed both when inserting a paper
roll for the first time and when replacing a roll once it is finished. Paper rolls of sizes
80 mm, 60 mm and 57.5 mm can be used on the printer, however for the 57.5/60 mm
rolls you must first install the paper roll Adapter kit.
Printhead: very
hot
Automatic cutter blade:
very sharp
Manual cutter blade: very sharp
1-5