Olivetti NETTUN@7000int'l Anwenderhandbuch Seite 108

DELETING THE EJ – CODE 459
To be able to reuse an SD-type memory device on which an electronic journal
has previously been registered, first of all its contents must be deleted and
then the card must be initialised.
In order to start the deletion procedure, an SD-type memory device that has
already been used must be loaded inside the cash register; in this case, proceed
as follows:
1. Press the [Config] key in the [Functions] > Other Functions environment.
The following screen appears:
2. Using the numeric keypad, enter the code 4 5 9 followed by X .
3. Start the DELETION procedure by touching the X . key on the touch screen.
Warning: executing the delete operation on the SD-type memory device
destroys all the data it contains therefore, afterwards, this data will no
longer be readable.
Note: Pressing the Delete key on the touch screen cancels the DELETION
procedure).
4. The message below is displayed on the touch screen.
5. The memory device has been deleted correctly. Open the door of the bay
containing the EJ card.
A message is displayed on the screen notifying that the door is open.
6. Close the door again. The cash register restarts automatically.
you may be asked to print (Z10) reports before proceeding with the deletion
Note:
operation. Print the report and then proceed with the procedure. For more
information consult the chapter "Printing Reports".
7. The cash register automatically starts the EJ initialisation procedure; follow the
instructions in the chapter "Initialising the Electronic Journal").
10-6
JOURNAL DELETED
OPEN COVER