Environmental Protection; Minimising Wear And Preventing Damage - Viking MR 4082 Gebrauchsanleitung

17. Environmental protection

Clippings should be composted
and not disposed of in
household waste.
The machine, its packaging and
accessories are all produced
from recyclable materials and must be
disposed of accordingly.
By disposing of materials separately, and
in an environmentally friendly manner,
valuable resources can be re-used. For
this reason, the machine should be
disposed of for recycling at the end of its
useful life.
Waste products such as used oil (engine
oil, gearbox oil), fuel and batteries must
always be disposed of properly. Observe
local regulations.
Remove the battery before disposing of
the machine.
Do not dispose of the battery with
domestic waste, but hand it in to a
specialist dealer or at a hazardous waste
collection point.
Consult your recycling centre or your
specialist dealer for information on the
proper disposal of waste products.
VIKING recommends VIKING specialist
dealers.
0478 193 9901 A - EN
18. Minimising wear and
preventing damage
Please always observe the following
important information for the prevention of
damage or excessive wear to your VIKING
machine:
1. Wearing parts
Some parts of the VIKING machine are
subject to normal wear even when used
properly and must be replaced in due time
depending on type and duration of use.
These include:
– Mowing blade
– Grass catcher box
– V-belt
– Battery
– Tyres, rollers
– Spark plugs
2. Compliance with the information in
this instruction manual
The VIKING machine must be used,
maintained and stored with the care
described in this instruction manual. Any
damage caused by non-compliance with
the safety, operating and maintenance
instructions is the sole responsibility of the
user.
This applies in particular to:
– Improper use of the product.
– Use of fuel and lubricants not approved
by VIKING (lubricants, petrol and
engine oil, see engine manufacturer's
specifications)
– Product modifications not approved by
VIKING.
– Use of tools or accessories which are
not approved or suitable for the
machine, or are of inferior quality.
– Use of the product for sporting or
competitive events.
– Resultant damage due to continued use
of the product with defective
components.
3. Maintenance operations
All operations listed in the section
"Maintenance" must be performed
regularly.
If these maintenance operations cannot be
carried out by the user, a specialist dealer
must be commissioned to perform them.
VIKING recommends that you have
maintenance operations and repairs
performed exclusively by a VIKING
specialist dealer.
VIKING specialist dealers regularly attend
training courses and are provided with
technical information.
If these operations are neglected, faults
may arise which are the responsibility of
the user.
These include:
– Corrosive and other resultant damage
caused by incorrect storage.
– Damage to the machine through the
use of inferior-quality spare parts.
– Damage due to untimely or inadequate
maintenance or damage due to
maintenance or repair work not
performed in the workshops of
specialist dealers.
119