Removing And Attaching The Grass; Catcher Box - Viking MR 4082 Gebrauchsanleitung

● When emptying the grass catcher box,
check the discharge chute for blockage
and clean if necessary.
● Check the wings of the mowing blade
for damage or wear and replace if
necessary.
Emptying the grass catcher box
● Disengage the mowing deck. (
The continuous tone ceases.
● Select the highest mowing deck cutting
level. ( 8.10)
● Drive the machine to the point at which
the clippings are to be emptied.
● Pull out the grass catcher box emptying
lever and push it forward. (
Grass catcher box swings upwards and
the clippings fall out.
● With the grass catcher box raised, it
may be necessary to drive forward
slightly, so that the clippings can fall out
of the grass catcher box.
● Briefly swing the grass catcher box up
and down so that the all the clippings
fall out.
● Slowly move the grass catcher box
emptying lever towards the rear and
allow the grass catcher box to re-
engage with the rear panel.
● Release the grass catcher box
emptying lever again and press down
until it has returned to the initial
retracted position.
92

11.9 Removing and attaching the grass

catcher box

The following points must be noted
before removing:
● Disengage the mowing deck. (
● Empty the grass catcher box. (
8.3)
● Engage the parking brake. (
● Stop the engine. (
When removing and attaching the
grass catcher box, the grass
catcher box release lever must
always be held in the released
position until the grass catcher box
8.11)
has been fully removed or attached.
Removing the grass catcher box
Pull the grass catcher box release lever (1)
upwards and hold.
8.3)
11.8)
8.9)
11.3)
Remove the grass catcher box (2).
0478 193 9901 A - EN