Herunterladen Inhalt Inhalt Diese Seite drucken

Storage For Prolonged Periods Without Operation; Disposal - Viking MR 4082 Gebrauchsanleitung

Vorschau ausblenden Andere Handbücher für MR 4082:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Only perform work on the mowing blades
when wearing thick work gloves and
exercising extreme care.
Check the function of the brakes at
regular, short intervals and, if necessary,
have the required adjustments or
maintenance operations performed by a
technician. VIKING recommends VIKING
specialist dealers.
Electrical system and battery:
In order to prevent sparks due to short
circuiting, the negative (–) cable must
always be disconnected from the battery
first and reconnected last.
Never smoke when working on
the battery. Sparks, naked
flames and other heat sources
must be kept away from the
battery.
Particular care is necessary when using
battery jump leads. Observe the relevant
instructions in order to prevent damage to
the ride-on mower (in particular, actuate
the starter for a maximum of 10 seconds).
(
11.2)
When charging the battery using another
charging system, observe the instructions
in section "Charging the battery".
(
13.18)
Never open the battery and do not drop it.
Always charge the battery in an enclosed,
well-ventilated room which is dry and
weather-protected.
Do not short circuit the battery
connections.
78
Deformed or faulty (leaking) batteries must
not be used and must be replaced and
disposed of in an environmentally-friendly
manner. Observe country-specific
legislation.
Fluid may escape from faulty batteries.
Avoid contact! In the case of inadvertent
contact, rinse with water. Seek medical
attention if the fluid contacts the eyes.
Escaping battery fluid can cause skin
irritation and burns.
Visually inspect the battery connection
cables for damage at regular intervals.
Have damaged cables replaced by a
technician.
Never bypass the fuses. Never use a fuse
with a value that differs from the specified
rating (ampere).
4.9 Storage for prolonged periods
without operation
Allow the engine to cool before storing the
machine in an enclosed space.
Store the ride-on mower with empty fuel
tank and the fuel reserve in a lockable and
well-ventilated room.
Never store the machine with petrol in the
fuel tank inside a building in which the
petrol fumes could come into contact with
naked flames or sparks.
If the tank has to be emptied
(e.g. immobilisation before the winter
break), the fuel tank must be emptied out
of doors only (empty the tank by running
the engine out of doors, for example).
Store the machine in good operational
condition.
The ignition key must always be removed
and kept in a safe place, to prevent
unauthorised or improper use by children
or other persons.
Thoroughly clean the ride-on mower
before storage (e.g. winter break). Dry
grass residues and leaves near to the
muffler may ignite. Danger of
combustion!
Allow the machine to cool down
completely before covering it.
Perform all the necessary maintenance
operations (lubrication etc.) before storing
the machine. (
13.1)
The battery cables must be disconnected if
the ride-on mower is immobilised for
longer periods. VIKING recommends
removing the battery and storing it in a dry
and locked place. (
13.18)
Ensure that batteries are protected from
unauthorised use (e.g. by children).

4.10 Disposal

Waste products such as used engine oil or
fuel, used lubricants, filters, batteries and
similar wearing parts can be harmful to
people, animals and the environment, and
must consequently be disposed of
properly.
Consult your recycling centre or your
specialist dealer for information on the
proper disposal of waste products. VIKING
recommends VIKING specialist dealers.
Ensure that old machines are properly
disposed of. Render the machine
unusable prior to disposal. In order to
prevent accidents, ensure that you remove
the ignition key, the battery and the ignition
lead on the engine.
0478 193 9901 A - EN

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Diese Anleitung auch für:

Mr 4082 k

Inhaltsverzeichnis