Carrying And Securing Lawn Mower; Environmental Protection; Minimising Wear And Preventing Damage - Viking ME 339 Gebrauchsanleitung

13. Transport
13.1 Carrying and securing lawn
mower
Risk of injury:
Observe the safety instructions in
the section "For your safety" (
Carrying the machine:
● Only lift the lawn mower by the
transport handles (1, 2). Always ensure
sufficient distance between the mowing
blade and your body, particularly your
feet and legs.
● Carry the lawn mower using both
hands, with one hand at the upper
transport handle (2) and the other hand
at the lower transport handle (1),
or
● carry the lawn mower with one hand at
the upper transport handle (2).
Securing the machine (lashing):
● Secure the lawn mower on the load
floor using suitable fastening materials.
● Attach ropes or straps at the handles
(1, 2).
0478 121 9917 C - EN
All manuals and user guides at all-guides.com

14. Environmental protection

Lawn clippings should be
composted and not disposed of
in household waste.
20
The machine, its packaging and
accessories are all produced
from recyclable materials and must be
disposed of accordingly.
4.).
By disposing of materials separately, and
in an environmentally friendly manner,
valuable resources can be re-used. For
this reason, the machine should be
disposed of for recycling at the end of its
useful life. Pay particular attention to the
information in the "Disposal" section
during disposal ( 4.7).
Consult your recycling centre or your
specialist dealer for information on the
proper disposal of waste products.
15. Minimising wear and
preventing damage
Please always observe the following
important information for the prevention of
damage or excessive wear to your VIKING
machine:
1. Wearing parts
Some parts of the VIKING machine are
subject to normal wear even when used
properly and must be replaced in due time
depending on type and duration of use.
These include:
– Blade
– Grass catcher box
2. Compliance with the information in
this instruction manual
The VIKING machine must be used,
maintained and stored with the care
described in this instruction manual. Any
damage caused by non-compliance with
the safety, operating and maintenance
instructions is the sole responsibility of the
user.
This applies in particular to:
– inadequately dimensioned power
cables (cross section),
– incorrect electrical connection
(voltage),
– product modifications not approved by
VIKING,
– the use of tools or accessories which
are not approved or suitable for the
machine, or are of inferior quality,
– improper use of the product,
43