Engine Cover - Viking MR 4082 Gebrauchsanleitung

Front axle: A = minimum 200 mm
Rear axle: B = minimum 120 mm
0478 193 9901 A - EN
Removing wheel
Remove the cap (1). Remove the retaining
ring (2) using a screwdriver.
Pull the large washer (3) together with the
wheel (5) off the wheel axle.
When removing the rear wheels,
ensure that the couplers (feather
keys) are not lost.
Installing wheel
Before installing the rear wheels,
ensure that a coupler (feather key)
is located in the groove of the wheel
axle on both sides.
The following points must be observed
before installing the wheels:
● Remove dirt from the wheel axle.
● Lightly coat the wheel axle with grease
before installation.
Insert feather key (5) in the rear wheel
axle. Push the wheel (4) with the large
washer (3) onto the wheel axle.
Allow retaining ring (2) to engage into the
groove on the wheel axle.
Fit cap (1) onto the wheel axle.

13.10 Engine cover

The engine cover can be folded up in order
to perform maintenance and cleaning work
on the engine. Sufficient space is available
for these operations when the engine
cover is folded up.
107