Viking MR 4082 Gebrauchsanleitung Seite 98

Removing rear V-belt cover
Danger of burns:
Allow the machine, particularly the
exhaust system, to cool down
completely before removing the
rear V-belt cover.
● Select the lowest cutting level.
Step 1:
Remove closure screw (1) by turning
through 90° anti-clockwise.
Step 2:
Pull the rear V-belt cover (2) forwards and
remove.
Detaching the V-belt
● Select cutting level 3.
96
Press V-belt tensioner lever (5) in the
direction of the arrow (forwards) using a
suitable length of pipe and hold.
Remove V-belt (2) from V-belt pulley (6).
● After removing the V-belt, slowly
release the V-belt tensioner lever.
Detaching the mowing deck at the rear
Danger of pinching:
Before pulling out the retaining pin,
ensure that no body parts (hands,
fingers, feet, etc.) are positioned
directly under the mowing deck.
Note
To facilitate removal, note and
carefully observe the specified
sequence.
Step 1:
Remove the cotter pin (3) from the
retaining pin (4).
Step 2:
Lift up the mowing deck (1) slightly and
hold. Detach and remove the retaining pin
(4).
Step 3:
Remove the cotter pin (3) from the
retaining pin (4).
Step 4:
Lift up the mowing deck (1) slightly and
hold. Detach and remove the retaining pin
(4).
● Carefully and slowly set down the
mowing deck.
0478 193 9901 A - EN