Start-Up; Setting Up Device; Connect/Disconnect Power Cord - Heidolph MR Hei-End Orginal-Betriebsanleitung

Start-Up

Setting up device


➜ Locate the device on a stable, horizontal and temperature resistant surface.
➜ Clean surface and feet with a damp cloth and ethanol regularly.

Connect/disconnect power cord


Connect power cord
The power cord comes with a three-wire
plug with recess on the bottom side.
The socket is located on the back side of
the unit.
✓ The device is switched OFF.
➜ Connect unit plug to the unit socket
with the recess facing down.
➜ Push plug up against socket until
securely attached.
➜ Connect power plug to power socket.
Disconnect power cord
➜ Disconnect power plug from power socket first.
➜ Then disconnect plug from socket on unit.
Warning:
Magnetic field!
The magnetic field beneath the hotplate could cause irritations on
your cardiac pacemaker, if you get too close.
Personnel with a cardiac pacemaker, implanted defibrillator or dosing
pump should keep a minimum distance of 10 cm (4 inches) to the
device.
Warning:
Risk of slipping device!
As a result of vibrations generated during operation the device might
slide off the table top.
The surface must be smooth, clean and temperature resistant and
should be properly leveled.
Start-Up
Unit plug
Unit socket
10
Power cord