Setup (Timer And Temperature Sensor) - Heidolph Synthesis 1 Betriebsanleitung

E

12. Setup (timer and temperature sensor)

In the setup mode the following parameters may be set:
•
Start Timer by turning heater or shaking action ON.
•
Such time being elapsed, heating action and shaking action are stopped the
same time; as another option, heater stops first, followed by shaking motion
after a certain delay.
•
Sensor
How to proceed:
Hold Set/Act key depressed and turn power switch to ON.
The following information appears in display:
Move cursor to place required with Select keys, thereafter hit Set/Act key
The following information appears in display:
At this point you may delay time for shaking action (after heater has been
disconnected). Such time being set by rotating the Value knob between 0 and 999
minutes.
96