Spare Parts; Accessories; Storing The Machine; Transporting, Installing And Connecting The Machine - Storch PS 40 Compact Handbuch

3.16 Spare parts

Spare parts must meet the technical requirements specified by the manufacturer. This is always guaranteed for original
spare parts.
Use only original spare parts. STORCH accepts no liability for damage caused by the use of non-original spare parts.

3.17 Accessories

Accessories must meet technical requirements stipulated by STORCH and be mutually compatible. This is always gua-
ranteed if you use of original accessories.
Accessories not included in the machine's scope of delivery are available from STORCH and can be purcha-
sed via our parts sales service. Refer to the product description and/or delivery note for details of the acces-
sories included.
The owner/operator is responsible for the use of the correct accessories. STORCH accepts no liability for damage
caused by the use of non-original accessories or the incorrect use of accessories.

3.18 Storing the machine

The machine may only be stored in a dry and frost-free location.
If there is a danger of frost at the storage location, you must take frost protection steps.
For further details refer to the chapter: „Decommissioning".

4.0 Transporting, installing and connecting the machine

This chapter contains information on safe transportation of the machine. In addition to this, you will also find descrip-
tions required for installing and connecting the machine. Commissioning of the machine is described in the chapter
„Commissioning".

4.1 Unpacking the machine

The machine is packed for transportation at the factory. Unpack the machine and dispose of the packaging material.
The packaging materials used can be recycled. Dispose of the material in line with applicable national envi-
ronmental protection rules.

4.2 Transporting the machine

The machine's basis equipment comprises five individual assemblies: drive unit, pump unit, compressor, control unit
and tubular chassis. Each assembly has an individual weight of less than 35 kg and can be moved without special
transportation aids or lifting gear. Ensure that the required transport locks are in place when transporting the machine!

4.3 Installation site

The operator is responsible for safe installation of the machine. Check the intended site
carefully and refuse the site in case of safety concerns.
Requirements for the installation site
The installation site must be:
• level
• large enough to provide sufficient space for the whole machine
• the machine must also be accessible from all sides for service and repair work.
Site
Select the machine site so that:
• the power cable is as short as possible; make sure that any extensions you use have a wire diameter of 2.5 mm
• Keep electric cables and water hoses as short as possible.
If you use a cable drum for the power supply, make sure that it is completely unreeled, even if the distance
from the mains to the machine does not require this!
114
.
2