Yanmar 6LPA-DTZP Bedienungsanleitung Seite 32

(4) Checking and Resupplying Marine drive Oil
①Refer to the instructions accompanying the marine drive for the amount of lube oil.
②Supply with the recommended oil if necessary.
(5) Checking and Resupplying Cooling Water
Burns from Scalding
Never remove the filler cap of the fresh water tank while the engine
●
is still hot. Steam and hot water will spurt out and seriously burn
you. Wait until the water temperature has dropped, then wrap a
cloth around the cap and loosen it slowly.
After inspection, refasten the filler cap firmly. If the cap is not secure,
●
steam or scalding water may be emitted during operation causing
burns.
①Check the cooling water level in the subtank.
If the water level is close to the minimum limit (indicated ''LOW''), remove the subtank cap and fill
with fresh water to the maximum limit (indicated ''FULL'').
②When the water level in the subtank is too low, remove the filler cap for the fresh water tank and
check the amount of cooling water in the fresh water tank. Fill with fresh water to overflowing if
the level is low.
Check the fresh water level before operation while the engine is cold.
●
Checking the water level while the engine is hot is dangerous, and the cooling water reading
will be misleading due to thermal expansion.
Check and supply cooling water daily at the subtank.
●
Do not remove the fresh water tank filler cap regularly.
The amount of water in the subtank will increase during operation. This is normal.
●
After stopping the engine, the cooling water cools down and the extra water in the sub tank
returns to the fresh water tank.
[NOTICE]
If the cooling water runs out too often, or if the water level in the fresh water tank falls
without any change in the subtank water level, there may be some leakage of water or
air. In such cases, consult your Yanmar dealer or distributor without delay.
(6) Checking the Remote Control Handle
Be sure to check that the remote control handle lever moves smoothly before use. If it is hard to
operate, lubricate the joints of the remote control cable and also the lever bearings. If the lever
comes out or there is play in the lever, adjust the remote control cable.
(7) Preparing Reserves of Fuel, Lube Oil, and Cooling Water
Have sufficient fuel ready for the day' s operation. In addition, have a reserve of fuel, lube oil, and
cooling water (sufficient for at least one refill) for the port close to the operation area in case of emer-
gencies.
→ See 3.5
→ See 3.4
DANGER
_ 26 _
→ See 5.2.4(4)(5)